Skip to content
Claims and service fees

Service fees, caps and limits: where to find them in your contract

The numbers that matter most are rarely on the front page. Here is where they usually hide and how to write them down.

By Editorial team3 min read
  • HVAC
  • Water heater
  • Plumbing
  • Electrical
  • Kitchen appliances
  • Laundry
  • Roof
  • Pool/spa

The price of a home warranty is more than the price of the plan. What you actually pay over a year depends on three other numbers: the service fee, the coverage caps, and any limits on how often or how much the company will pay. We are not going to tell you what those numbers should be. We are going to show you where to find yours.

The service fee

A service fee is what you pay each time a technician comes out for a claim. Some contracts call it a trade call fee or a deductible. It is usually printed on the first page or in a summary box near the start.

Check the service fee listed in your contract, then look for a few details next to it. Is it charged per visit, or per claim? If the technician has to come back for parts, do you pay again? If two items break on the same day, is it one fee or two?

  • Where is the service fee printed?
  • Is it per visit or per claim?
  • Does a return visit for the same problem cost another fee?
  • Is there a different fee for certain items?

Coverage caps

A coverage cap is the most the company will pay for a single item or a single claim. There may be a cap per item, a cap per system, and a cap for the whole contract term. These usually appear in a table or in the description of each covered item.

Caps matter most for expensive systems, like heating and cooling. If replacing a system would cost more than the cap, you pay the difference. Write down the cap for each system you care about, exactly as the contract states it.

Limits that are not dollar amounts

Not every limit is a dollar figure. Some contracts limit how many claims you can make on one item. Some limit which parts are covered. Some say they will not cover certain work, like refrigerant, crane rental, or removing old equipment, or they will cover it only up to a set amount.

These details are often in the exclusions section or in small notes under the coverage table. Read both.

Build a one-page cheat sheet

Once you find these numbers, put them on one page. You do not need anything fancy. A simple list will do: the service fee and how it is charged, the cap for each covered system, the overall cap if there is one, and any special limits you found.

Keep that page with your contract. When something breaks, you will know what to expect before you call. And when you compare plans, you can line up the same items side by side.

Ask about anything unclear

If you cannot find a number, ask the company in writing where it appears. A good contract should be able to answer "what is the cap for my water heater?" with a page number.

If the answer is "it depends," ask what it depends on. Write that down too.

A worked way to think about it

Picture a single year with your plan. Say two things break: the dishwasher in spring and the furnace in winter. For each one, you would pay the service fee listed in your contract. If the furnace needs a part that is only partly covered, you would also pay whatever falls above the cap or outside the parts list.

Now picture a year where nothing breaks. You still paid for the plan, but no service fees. Neither year is the "right" one to plan for. Thinking through both helps you see how the fee, the caps and the plan price work together, using the numbers from your own contract rather than anyone's estimate.

Use our worksheet

Our printable comparison worksheet has rows for the service fee, coverage caps, and claim process, with blank columns for up to three plans. Fill it in with the numbers from each contract exactly as written. It makes the differences hard to miss.

This guide is general information, not advice about any specific plan or contract. Always read your own contract.